DISASSEMBLY
PROCEDURE
1. REMOVE FRONT NO. 1 LOWER ARM BUSH LH
(a) Using a chisel and hammer, pry the flange of the bush outward. |
|
(b) Using SST and a press, press out the bush. SST: 09632-36010 SST: 09950-00020 SST: 09950-60010 09951-00400 |
|
2. REMOVE FRONT NO. 2 LOWER ARM BUSH LH
(a) Using a chisel and hammer, pry the flange of the bush outward. |
|
(b) Using SST and a press, press out the bush. SST: 09632-36010 SST: 09950-00020 SST: 09950-60010 09951-00400 |
|
3. REMOVE LOWER BALL JOINT DUST COVER LH
(a) Using a snap ring expander, remove the dust cover set ring and dust cover from the lower arm. NOTICE:
|
|
Operation Check
OPERATION CHECK
1. CHECK AUTOMATIC RUNNING BOARD OPERATION
(a) When side auto step switch assembly is "AUTO", the operation and condition
of this control are described below.
Check that the driver side automatic running board operates as follows ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System)
(See page )
2. REMOVE ...