DISASSEMBLY
PROCEDURE
1. REMOVE FRONT SUSPENSION UPPER ARM BUSH LH
HINT:
Use the same procedure for the front and rear sides.
(a) Using a hammer and chisel, strike and bend the entire flange of the upper arm bush as shown in the illustration. |
|
(b) Using SST and a press, press out the bush. SST: 09613-26010 SST: 09710-22021 09710-01031 SST: 09950-00020 |
|
2. REMOVE FRONT UPPER BALL JOINT DUST COVER LH
(a) Using a snap ring expander, remove the dust cover set ring and dust cover from the upper arm. NOTICE:
|
|
Output Speed Sensor Circuit No Signal (P0722)
DESCRIPTION
The speed sensor SP2 detects the rotation speed of the transmission output shaft
and sends signals to the ECM. The ECM determines the vehicle speed based on these
signals. An AC voltage is generated in the speed sensor SP2 coil as the parking ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH
(a) As shown in the illustration, flip the ball joint stud back and forth
5 times before installing the nut.
(b) Using ...