Toyota 4Runner: Disassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Door / Hatch / Hood / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE HOOD TO RADIATOR SUPPORT SEAL

(a) Using a clip remover, remove the 7 clips and hood to radiator support seal.

NOTICE:

If the clips are damaged or fall off, replace them with new clips.

2. REMOVE HOOD INSULATOR

(a) Using a clip remover, remove the 10 clips.

NOTICE:

If the clips are damaged or fall off, replace them with new clips.

(b) Detach the 2 claws to remove the hood insulator.

3. REMOVE HOOD BULGE (w/ Hood Bulge)

(a) Remove the 4 nuts.

(b) Detach the 3 clips from the back side of the hood panel.

(c) Using a moulding remover, detach the 2 guides to remove the hood bulge together with the hood air intake guide as shown in the illustration.

4. REMOVE HOOD AIR INTAKE GUIDE (w/ Hood Bulge)

(a) Detach the 4 claws to remove the hood air intake guide.

5. REMOVE NO. 1 HOOD BULGE PROTECTOR (w/ Hood Bulge)

(a) Remove the 2 No. 1 hood bulge protectors.

6. REMOVE NO. 2 HOOD BULGE PROTECTOR (w/ Hood Bulge)

(a) Remove the 2 No. 2 hood bulge protectors.

7. REMOVE NO. 3 HOOD BULGE PROTECTOR (w/ Hood Bulge)

(a) Remove the No. 3 hood bulge protector.

8. REMOVE WASHER NOZZLE SUB-ASSEMBLY

9. DISCONNECT WASHER HOSE ASSEMBLY

(a) Detach the 5 clamps to disconnect the washer hose assembly.

10. REMOVE HOOD SUPPORT ASSEMBLY LH

11. REMOVE HOOD SUPPORT ASSEMBLY RH

HINT:

Use the same procedure for the LH side and RH side.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas A through E are within each standard range. Standard: Area ...

Other materials about Toyota 4Runner:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Power Steering System DTC Code D ...

VFC Solenoid Circuit (C15F0)
DESCRIPTION This circuit supplies electric power to the power steering solenoid valve. The power steering ECU assembly controls the output current to the power steering solenoid valve in accordance with the steering angle signal, steering zero point memo ...