Toyota 4Runner: Disassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Automatic Running Board / Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE STEP PLATE COVER LH

(a) Remove the 2 screws and step plate cover LH.

2. REMOVE STEP PLATE COVER RH

HINT:

Use the same procedure as described for the step plate cover LH.

3. REMOVE SIDE AUTO STEP MOTOR ASSEMBLY

(a) Disengage the 4 clamps.

(b) Remove the bolt.

4. REMOVE FLOOR SIDE SILL STAY

(a) Remove the 6 bolts and floor side sill stay.

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE ROCKER PANEL MOULDING (w ...

Inspection

INSPECTION PROCEDURE 1. INSPECT SIDE AUTO STEP MOTOR ASSEMBLY (a) Check that the motor gear rotates smoothly as follows. NOTICE: Do not apply positive (+) battery voltage to any te ...

Other materials about Toyota 4Runner:

Rear Door LH ECU Communication Stop (B2324)
DESCRIPTION This DTC is stored when LIN communication between the rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC Code DTC Detection Condition ...

Power Steering ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Power Steering ECU Communication Stop Mode Either condition is met: "PPS" is not displayed on the "CAN Bus Check" sc ...