DISASSEMBLY
PROCEDURE
1. REMOVE RADIATOR GRILLE
2. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
(a) Remove the 2 screws to remove the front bumper extension mounting bracket. |
|
3. REMOVE LOWER FRONT VALANCE PANEL (w/ Garnish)
(a) Remove the 13 outside moulding retainers and lower front valance panel as shown in the illustration. |
|
4. REMOVE LOWER NO. 1 RADIATOR GRILLE
(a) Remove the clip. |
|
(b) Detach the 13 claws to remove the lower No. 1 radiator grille.
5. REMOVE FRONT BUMPER REINFORCEMENT STOPPER RH (for RH Side)
(a) Detach the 2 claws and guide to remove the front bumper reinforcement stopper RH. |
|
6. REMOVE FOG LIGHT ASSEMBLY LH
7. REMOVE FOG LIGHT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
8. REMOVE FOG LIGHT COVER LH
(a) Remove the outside moulding retainer. |
|
(b) Detach the 5 claws to remove the fog light cover LH.
9. REMOVE FOG LIGHT COVER RH
HINT:
Use the same procedure as for the LH side.
Open in Inside Luggage Compartment Electrical Key Oscillator Circuit (B27A7)
DESCRIPTION
The certification ECU generates a request signal and transmits the signal to
the indoor No. 2 electrical key antenna (inside luggage). The indoor No. 2 electrical
key antenna (inside luggage) detects that the electrical key is inside the vehic ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble
areas listed for that code. For details of the code, refer to the "See page"
below.
*: The air conditioning amplifier stor ...