DISASSEMBLY
PROCEDURE
1. REMOVE RADIATOR GRILLE
2. REMOVE NO. 2 ENGINE ROOM WIRE
(a) Disconnect each connector.
(b) Detach the 9 clamps to remove the No. 2 engine room wire.
3. REMOVE NO. 1 ULTRASONIC SENSOR
4. REMOVE ULTRASONIC SENSOR CLIP
5. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
6. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
(a) Remove the 2 screws and front bumper extension mounting bracket. |
|
7. REMOVE FRONT BUMPER SIDE MOULDING LH
(a) Remove the 2 outside moulding retainers. |
|
(b) Detach the claw to remove the front bumper side moulding LH.
8. REMOVE FRONT BUMPER SIDE MOULDING RH
HINT:
Use the same procedure as for the LH side.
9. REMOVE FRONT BUMPER LOWER SIDE SUPPORT LH
(a) Remove the 2 clips. |
|
(b) Detach the 5 claws to remove the front bumper lower side support LH.
10. REMOVE FRONT BUMPER LOWER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
11. REMOVE NO. 2 RADIATOR GRILLE MOULDING
(a) Remove the 2 outside moulding retainers and 4 screws. |
|
(b) Detach the 4 claws to remove the No. 2 radiator grille moulding. |
|
12. REMOVE FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH
(a) Remove the 3 outside moulding retainers. |
|
(b) Remove the 2 screws.
(c) Detach the 2 claws and guide to remove the front bumper side moulding sub-assembly LH.
13. REMOVE FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
14. REMOVE FRONT BUMPER MOULDING SUB-ASSEMBLY
(a) Remove the 4 screws. |
|
(b) Remove the 15 outside moulding retainers. |
|
(c) Detach the 12 guides and 4 claws to remove the front bumper moulding sub-assembly. |
|
15. REMOVE FOG LIGHT ASSEMBLY LH
16. REMOVE FOG LIGHT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
Inspection
INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
(a) Remove the washer jar.
(b) Disconnect the windshield washer motor and pump connector.
HINT:
Make sure that the windshield washer motor and pump is installed to the washer
jar ...
Changing the registered name of a portable player
Select “Change Name” using a
voice command or .
Select the name of the portable
player to be changed by either of the following methods, and select “Confirm”
using a voice command or :
a. Press the talk switch and say the name of desired port ...