DISASSEMBLY
PROCEDURE
1. REMOVE REAR BUMPER LOWER COVER (w/ Garnish)
(a) Remove the 2 clips and 14 outside moulding retainers. |
|
(b) Detach the claw to remove the rear bumper lower cover
2. REMOVE REAR BUMPER EXTENSION (w/o Pintle Hook)
(a) Remove the 2 clips and 2 outside moulding retainers. |
|
(b) Detach the 4 claws to remove the rear bumper extension.
3. REMOVE REAR BUMPER EXTENSION (w/ Pintle Hook)
(a) Remove the 2 clips and 2 outside moulding retainers. |
|
(b) Detach the 4 claws to remove the rear bumper extension.
4. REMOVE REAR BUMPER SIDE BRACKET LH
(a) Remove the clip and 2 screws. |
|
(b) Detach the guide to remove the rear bumper side bracket LH.
5. REMOVE REAR BUMPER SIDE BRACKET RH
HINT:
Use the same procedure as for the LH side.
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD
(a) Support the steering pad with one hand.
(b) Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to ...
Reverse Signal Circuit
DESCRIPTION
The navigation receiver assembly receives a reverse signal from the park/neutral
position switch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed
t ...