Toyota 4Runner: Disassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Lighting (ext) / Fog Light Assembly / Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FOG LIGHT BULB

(a) Turn the bulb in the direction indicated by the arrow and pull to remove it.

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER COVER ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor and magnetic clutch with a new one, gradually discharge the refrigerant gas from the service valve and drain the following amount of oil from the new compressor and magnet ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 3 FLOOR WIRE (a) Disconnect the 4 connectors and remove the 3 pieces of tape. (b) Detach the 4 clamps to remove the No. 3 floor wire. 2. REMOVE REAR BUMPER SIDE BRACKET LH (a) Remove the clip and 2 screws. ...

Toyota 4Runner: Disassembly

Components

Removal

Other materials about Toyota 4Runner: