DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 HEATER TO REGISTER DUCT
(a) Remove the 4 screws and No. 1 heater to register duct. |
|
2. REMOVE NO. 2 HEATER TO REGISTER DUCT
(a) Remove the 4 screws and No. 2 heater to register duct. |
|
3. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
(a) Remove the screw. |
|
(b) Detach the 2 claws to remove the No. 1 side defroster nozzle duct.
4. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
(a) Remove the screw. |
|
(b) Detach the 2 claws to remove the No. 2 side defroster nozzle duct.
5. REMOVE NO. 3 HEATER TO REGISTER DUCT
(a) Remove the 2 screws. |
|
(b) Detach the claw to remove the No. 3 heater to register duct.
6. REMOVE DEFROSTER NOZZLE ASSEMBLY
(a) Remove the 3 screws and defroster nozzle assembly. |
|
7. REMOVE ACCESSORY METER ASSEMBLY
8. REMOVE TELLTALE LIGHT ASSEMBLY
9. REMOVE NO. 2 INSTRUMENT PANEL WIRE
(a) Disconnect the connector.
(b) Detach the 17 clamps to remove the No. 2 instrument panel wire.
10. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
11. REMOVE AUTOMATIC LIGHT CONTROL SENSOR
12. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FOG LIGHT COVER LH
(a) Attach the 5 claws to install the fog light cover LH.
(b) Install the outside moulding retainer.
2. INSTALL FOG LIGHT COVER RH
HINT:
Use the same procedure as for the LH side.
3. INSTALL FOG LIGHT ...
Image from Camera for Rear View Monitor is Abnormal
DESCRIPTION
The display signal from the rear television camera assembly transmits to the
radio and display receiver assembly.
WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR
...