Toyota 4Runner manuals

Toyota 4Runner: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)


(a) Remove the No. 1 roof silencer pad.

2. REMOVE NO. 2 ROOF SILENCER PAD


(a) w/o Sliding Roof:

Remove the 2 No. 2 roof silencer pads.

(b) w/ Sliding Roof:

Remove the No. 2 roof silencer pad.


3. REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)


(a) Remove the No. 3 roof silencer pad.

4. REMOVE NO. 4 ROOF SILENCER PAD


(a) w/o Sliding Roof:

Remove the No. 4 roof silencer pad.

(b) w/ Sliding Roof:

Remove the No. 4 roof silencer pad.


5. REMOVE VANITY LIGHT ASSEMBLY


HINT:

Use the same procedure for the other vanity light.

(a) Detach the 2 claws labeled A and separate the bulb holder from the vanity light as shown in the illustration.

(b) Detach the claw labeled B and remove the vanity light.

Text in Illustration

*1

Claw A

*2

Claw B

*3

Bulb Holder

6. REMOVE NO. 1 ROOF WIRE

(a) Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

(b) Detach each clamp and remove the tape and No. 1 roof wire.

Text in Illustration

*A

w/o Sliding Roof

*B

w/ Sliding Roof

*C

w/ EC Mirror

-

-

*1

Visor Connector

*2

Marking Tape

7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

(a) w/o Sliding Roof:

Remove the No. 2 antenna cord sub-assembly (See page ).


(b) w/ Sliding Roof:

Remove the No. 2 antenna cord sub-assembly (See page ).


Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (a) w/o Sliding Roof: Install the No. 2 antenna cord sub-assembly (See page ). (b) w/ Sliding Roof: Install the No. 2 antenna co ...

Other materials about Toyota 4Runner:

Accumulator Solenoid Malfunction / Upside (C1831/31,C1832/32)
DESCRIPTION The stabilizer control ECU receives information from the steering angle sensor, skid control ECU (speed signal) and yaw rate and acceleration sensor via CAN communication. Based on this information, the stabilizer control ECU turns the stabili ...

Back Door Speaker
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY ...

© 2016-2024 | www.to4runner.net

0.0269