DISASSEMBLY
PROCEDURE
1. REMOVE REAR AXLE SHAFT SNAP RING LH
(a) Using a snap ring expander, remove the snap ring.
2. REMOVE REAR AXLE SHAFT LH
(a) Using SST and a press, press out the rear axle shaft.
SST: 09521-25023
SST: 09521-25011
(b) Grind the rear axle bearing retainer using a grinder, and then remove it with a chisel. |
|
(c) Remove the shaft washer from the axle shaft.
3. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
(a) Temporarily install 4 nuts to the housing bolts.
NOTICE:
Do not use any nuts removed from the vehicle, as they may be damaged.
(b) Using a hammer, remove the 4 housing bolts and rear axle hub and bearing.
(c) Remove the 4 nuts.
4. REMOVE BRAKE DRUM OIL DEFLECTOR LH
(a) Using SST, remove the 6 hub bolts.
SST: 09650-17011
NOTICE:
(b) Remove the deflector and deflector gasket from the rear axle shaft.
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT
(a) Prepare the vehicle:
Ma ...
Rear Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE REAR WIPER BLADE
(a) Apply protective tape to the areas shown in the illustration.
Text in Illustration
*1
Protective ...