DISASSEMBLY
PROCEDURE
1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP
(a) Hold the drive shaft lightly in a vise between aluminum plates.
(b) Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration. |
|
2. REMOVE FRONT NO. 1 AXLE INBOARD JOINT BOOT CLAMP
(a) Remove the front axle inboard joint boot clamp.
HINT:
Perform the same procedures as for the front No. 2 axle inboard joint boot clamp.
3. REMOVE FRONT AXLE INBOARD JOINT BOOT
4. REMOVE FRONT AXLE INBOARD JOINT SET
(a) Place matchmarks on the tripod and the inboard and outboard joint shafts. Text in Illustration
NOTICE: Do not punch the marks. |
|
(b) Remove the inboard joint from the outboard joint shaft.
(c) Using a snap ring expander, remove the snap ring. |
|
(d) Place matchmarks on the outboard joint shaft and tripod. Text in Illustration
NOTICE: Do not punch the marks. |
|
(e) Using a brass bar and hammer, remove the tripod from the drive shaft.
NOTICE:
Do not tap the roller.
5. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP
(a) Using a screwdriver, remove the outboard joint boot clamps. HINT: If the outboard joint boot clamps that have been replaced are installed to the drive shaft, use a side cutter to remove them. |
|
6. REMOVE FRONT NO. 1 AXLE OUTBOARD JOINT BOOT CLAMP
(a) Using pliers, remove the boot clamp, as shown in the illustration.
7. REMOVE OUTBOARD JOINT BOOT
8. REMOVE SHAFT SNAP RING
(a) Using a screwdriver, remove the snap ring.
9. REMOVE FRONT DRIVE SHAFT DUST COVER
(a) Using SST and a press, remove the dust cover.
SST: 09950-00020
System Diagram
SYSTEM DIAGRAM
w/ Smart Key System
No.
ECU/Sensor Name
1
Combination meter assembly
2
Skid control ECU (master cylinder solenoid)*1
3
Main body ECU (mu ...
Pump Motor Relay (C1253)
DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid
and drives the pump motor based on a signal from the skid control ECU.
DTC Code
DTC Detection Condition
Trouble Area
...