Toyota 4Runner: Disposal

Toyota 4Runner Service Manual / Suspension / Suspension Control / Stabilizer Control Valve(w/ Kdss) / Disposal

DISPOSAL

PROCEDURE

1. DISPOSE OF STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY

(a) Using a drill, make a hole in the areas of the accumulator housing indicated in the illustration to discharge the gas inside.

CAUTION:

Be careful and always use the proper safety equipment when drilling because shards of metal may fly about.
The gas is colorless, odorless and non-poisonous.

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Suspension Control System(w/ Kdss)

...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY (a) If there are any defects as mentioned below, replace the spiral cable with a new one: Scratches, cracks, dents or chips in the connector or spiral cable. (b) Check the spiral cable. Text in ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ign ...