Toyota 4Runner: Disposal
DISPOSAL
PROCEDURE
1. DISPOSE OF BRAKE BOOSTER ACCUMULATOR ASSEMBLY
|
(a) Place the brake booster accumulator assembly in a vise and cover it with cloth. |
|
(b) Using a saw, cut the brake booster accumulator body between A and B as shown in the illustration to discharge the gas inside.
CAUTION:
- Cover the accumulator with a piece of cloth when working because gas may blow out.
- Cut the accumulator carefully, not abruptly.
- Wear protective glasses.
(c) When the outer body of the brake booster accumulator is cut, gas and liquid discharge.
HINT:
The gas is colorless, odorless and non-poisonous.
Installation
INSTALLATION
PROCEDURE
1. INSTALL BRAKE BOOSTER GASKET
(a) Install a new brake booster gasket to the hydraulic brake booster.
2. INSTALL HYDRAULIC BRAKE BOOSTER ASSEMBLY
(a) Install the hydraulic ...
Parking Brake
...
Other materials about Toyota 4Runner:
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
When installing the back door outside garnish seal, heat the back door outside
garnish surface using a heat light.
Standard:
Item
Temperature
Back Door Outside Garnish
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after d ...
0.0187