DESCRIPTION
The main body ECU controls the door mirror foot light.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
PERFORM ACTIVE TEST USING TECHSTREAM (DOOR MIRROR FOOT LIGHT) |
(a) Using the Techstream, perform the Active Test (See page ).
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
---|---|---|---|
Side Mirror Foot Light |
Door mirror foot light |
ON/OFF |
- |
OK:
Door mirror foot light comes on.
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
2. |
CHECK HARNESS AND CONNECTOR (OUTER MIRROR - MAIN BODY ECU AND BODY GROUND) |
(a) Disconnect the I4 and H4 outer mirror connectors.
(b) Disconnect the F10 main body ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LH
Tester Connection |
Condition |
Specified Condition |
---|---|---|
I4-1 (MLP) - F10-4 (MILE) |
Always |
Below 1 Ω |
I4-7 (MLP-) - Body ground |
Always |
Below 1 Ω |
I4-1 (MLP) - Body ground |
Always |
10 kΩ or higher |
for RH
Tester Connection |
Condition |
Specified Condition |
---|---|---|
H4-1 (MLP) - F10-4 (MILE) |
Always |
Below 1 Ω |
H4-7 (MLP-) - Body ground |
Always |
Below 1 Ω |
H4-1 (MLP) - Body ground |
Always |
10 kΩ or higher |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
(e) Check for DTCs.
2. CLEAR DTC ...
Clock
1. Adjusts the hours
2. Adjusts the minutes
For quicker adjustment of the clock
To advance the minutes and hours quickly, press and hold the “M” or “H”
button.
The time can be adjusted back or forth by following the procedure below:
The hou ...