DTC CHECK / CLEAR
1. CHECK DTC (USING TECHSTREAM)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
(f) Read the DTCs following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
2. CHECK DTC (USING SST CHECK WIRE)
(a) Turn the ignition switch off.
(b) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
SST: 09843-18040
Text in Illustration
*a |
Front view of DLC3 |
(c) Turn the ignition switch to ON.
(d) Read and record any DTCs from the tire pressure warning light in the combination meter.
HINT:
Trouble Area |
See page |
---|---|
Tire pressure warning light circuit |
|
TC and CG terminal circuit |
|
(e) Refer to the Diagnostic Trouble Code Chart (See page ) for DTC information.
(f) After completing the check, turn the ignition switch off and remove SST from the DLC3.
SST: 09843-18040
3. CLEAR DTC
HINT:
After repairing the malfunctions, clear the DTCs.
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
(f) Clear the DTCs following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
Power windows
The power windows can be opened and closed using the switches.
Operating the switch moves the windows as follows:
1. Closing
2. One-touch closing*
3. Opening
4. One-touch opening* *: Pushing the switch in the opposite direction will stop
window tra ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and
window frame moulding using a ...