DTC CHECK / CLEAR
1. CHECK DTC
(a) Turn the side auto step switch assembly to OFF.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Main Body / Active Test.
(f) Turn the Active Test "Power Running Board Forced Retracting" to ON.
(g) Open either the front or rear door on the driver side and the front or rear door on the passenger side.
(h) Turn the side auto step switch assembly from AUTO to OFF 5 times in succession within 3 seconds.
(i) Check the number of times that the automatic running board warning light on the combination meter flashes.
HINT:
(j) Turn the Active Test "Power Running Board Forced Retracting" to OFF to finish DTC check.
Removal
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
(a) Remove the headrest.
2. REMOVE REAR SEAT TRACK INNER BRACKET COVER
(a) Using a mouldi ...
Zero Point Calibration of Acceleration Sensor Undone (C1879/79)
DESCRIPTION
The stabilizer control ECU receives the yaw rate and acceleration sensor zero
point information from the skid control ECU via CAN communication.
DTC Code
DTC Detection Condition
Trouble Area
C18 ...