Toyota 4Runner manuals

Toyota 4Runner: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / DTC.

(e) Read the DTCs.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / DTC.

(e) Clear the DTCs.

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Front Power Seat Control System DTC Code Detection Item See page B2650 Slide Sensor Malfunction ...

Other materials about Toyota 4Runner:

Short to GND in Hall Effect Sensor Power Circuit (31)
DESCRIPTION When there is a short to GND in the side auto step motor hall sensor power circuit, the side auto step controller ECU assembly does not operate the automatic running board. DTC No. Detection Condition Trouble ...

Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH 2. REMOVE COWL SIDE TRIM BOARD LH 3. REMOVE NO. 2 SWITCH HOLE BASE 4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY ...

© 2016-2026 | www.to4runner.net

0.0116