Toyota 4Runner: Dtc Check / Clear

Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/ Smart Key System) / Dtc Check / Clear

DTC CHECK / CLEAR

HINT:

When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
Refer to the Techstream operator's manual for further details.

1. CHECK FOR IMMOBILISER DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Check for DTCs.

2. CHECK FOR ECM DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Check for DTCs.

3. CLEAR IMMOBILISER DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Clear the DTCs.

4. CLEAR ECM DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Clear the DTCs.

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" bel ...

Theft Deterrent System Communication Line High Fixation (B279A)

DESCRIPTION If the communication line (EFIO-IMI) to the ID code box is stuck on HI output, the ECM stores this DTC. DTC Code DTC Detection Condition Trouble Area ...

Other materials about Toyota 4Runner:

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) The air conditioning system has the following controls. Control Outline Neural Network Control This control is capable of performing complex control by artificially simu ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Hold the drive shaft lightly in a vise between aluminum plates. (b) Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration ...