Toyota 4Runner: Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Check for DTCs.
HINT:
Refer to the Techstream operator's manual for further details.
2. CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Clear the DTCs by following the directions on the Techstream display.
HINT:
Refer to the Techstream operator's manual for further details.
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) Smart key system (for start function) data and the Diagnostic Trouble Codes
(DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When
t ...
Detecting Vehicle Submersion (B2277)
DESCRIPTION
This DTC is stored when a malfunction in the submersion monitor circuit inside
the power management control ECU is detected.
HINT:
When the power management control ECU is replaced wi ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Attach the claw to install the occupant classification ECU.
NOTICE:
If the occupant classification ECU has been dropped, or there are any
cracks, dents or other defects i ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
NOTICE:
The regulator arm must be below the intermediate position when installing the
power window regulator motor.
(a) Using a T25 "TORX" socket wrenc ...
0.0255