Toyota 4Runner manuals

Toyota 4Runner: Dtc Check / Clear

DTC CHECK / CLEAR

1. DTC CHECK/CLEAR (Using the Techstream)

(a) Check DTC:

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Body Electrical / Telematics / Trouble Codes.

(5) Check the DTCs.

(b) Clear DTC:

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Body Electrical / Telematics / Trouble Codes.

(5) Clear the DTCs.

Diagnosis System
DIAGNOSIS SYSTEM 1. CHECK DLC3 (a) Check the DLC3 (See page ). 2. CHECK INDICATOR (a) When a malfunction is detected in the Safety Connect system, the manual (SOS) switch red indicator on the m ...

Prl Update
PRL UPDATE 1. PRL UPDATE This function updates the PRL (Preferred Roaming List) of the DCM (Telematics Transceiver). The PRL is a large set of phone numbers the DCM (Telematics Transceiver) can ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster. PROCEDURE 1. DRAIN BRAKE FLUID NOTICE: Wash off brake fluid immediately if it comes in contact w ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. When installing the window frame moulding, black out tape and outside stripe, heat the vehicle body ...

© 2016-2024 | www.to4runner.net

0.0257