Toyota 4Runner: ECU Power Source Circuit

Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/o Smart Key System) / ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.	CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)

(a) Disconnect the F34 ECU connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Switch Condition	Specified Condition
F34-1 (+B) - Body ground	Always	11 to 14 V
F34-2 (IG) - Body ground	Ignition switch off	Below 1 V
F34-2 (IG) - Body ground	Ignition switch ON	11 to 14 V

Standard Resistance:

Tester Connection	Condition	Specified Condition
F34-16 (GND) - Body ground	Always	Below 1 Ω

Text in Illustration

*a	Front view of wire harness connector (to Transponder Key ECU Assembly)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPAIR OR REPLACE HARNESS OR CONNECTOR

Security Indicator Light Circuit

DESCRIPTION When the engine immobiliser system is set, the security indicator light blinks continuously, but does not illuminate if the engine immobiliser system is not set. WIR ...

Id Code Box

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL ID CODE BOX (a) Attach the 2 claws and move the ID code box in the direction of the arrow. ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY (a) Install the stereo component amplifier to the No. 1 speaker assembly with box with the 3 bolts. 2. INSTALL NO. 1 SPEAKER ASSEMBLY WITH BOX (a) Attach the 2 claws, lower ...

Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION Refer to DTC P0711 (See page ). DTC Code DTC Detection Condition Trouble Area P0712 ATF temperature sensor resistance is below 79 Ω for 0.5 sec. or more (1-trip detection logic ...