The vehicle’s keys have built-in transponder chips that prevent the engine from starting if a key has not been previously registered in the vehicle’s on-board computer.
Never leave the keys inside the vehicle when you leave the vehicle.
Vehicles without a smart key system
The indicator light flashes after the key has been removed from the engine switch to indicate that the system is operating.
The indicator light stops flashing after the registered key has been inserted into the engine switch to indicate that the system has been canceled.
Vehicles with a smart key system
The indicator light flashes after the “ENGINE START STOP” switch has been turned off to indicate that the system is operating.
The indicator light stops flashing after the “ENGINE START STOP” switch has been turned to ACCESSORY or IGNITION ON mode to indicate that the system has been canceled.
System maintenance
The vehicle has a maintenance-free type engine immobilizer system.
Conditions that may cause the system to malfunction
• If the grip portion of the key is in contact with a metallic object
• If the key is in close proximity to or touching a key to the security system
(key with a built-in transponder chip) of another vehicle
Certifications for the engine immobilizer system (vehicles without a smart key system)
• For vehicles sold in the U.S.A.
FCC ID: MOZRI-33BTY
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• For vehicles sold in Canada
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION
Certifications for the immobilizer system
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTICE
To ensure the system operates correctly
Do not modify or remove the system. If modified or removed, the proper operation of the system cannot be guaranteed.
Yaw Rate Sensor Malfunction (C1436)
DESCRIPTION
Refer to DTC C1419 and C1435 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1436
Either condition is met:
With the vehicle stationary, the yaw rate and accel ...
Front Power Seat does not Operate with Front Power Seat Switch
DESCRIPTION
When a signal is input into the front power seat switch LH (position control
ECU), the ECU manages the signals received from the front power seat switch LH and
operates each motor. When 2 or more signals are input, the motors only operate when ...