Toyota 4Runner: Entire Combination Meter does not Operate

Toyota 4Runner Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Entire Combination Meter does not Operate

DESCRIPTION

This circuit is the power source circuit for the meter. This circuit provides two types of power sources; one is a constant power source mainly used as a backup power source, and the other is an IG power source mainly used for signal transmission. The constant power source is mainly used as a backup power source for the meter CPU, however, it is also used for CAN communication. If a voltage of 12 V is not applied to terminal IG+ when the ignition switch is turned to ON, the indicators will not operate.

WIRING DIAGRAM

PROCEDURE

1.	CHECK HARNESS AND CONNECTOR

(a) Disconnect the F14 meter connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
F14-20 (E1) - Body ground	Always	Below 1 Ω
F14-13 (MGND) - Body ground	Always	Below 1 Ω

Standard Voltage:

Tester Connection	Condition	Specified Condition
F14-17 (IG+) - Body ground	Ignition switch ON	11 to 14 V
F14-15 (B) - Body ground	Always	11 to 14 V

Text in Illustration

*a	Front view of wire harness connector (to Combination Meter Assembly)

REPLACE COMBINATION METER ASSEMBLY

REPAIR OR REPLACE HARNESS OR CONNECTOR

Lost Communication with ECM / PCM "A" (U0100,U0129,U0131,U0151)

DESCRIPTION The combination meter assembly communicates with the ECM via the CAN communication system (CAN No. 1 Bus). DTC Code. DTC Detection Condition Trouble Ar ...

Speedometer Malfunction

DESCRIPTION The combination meter receives vehicle speed signals from the skid control ECU via the CAN communication line. The wheel speed sensors output voltages that vary according to the vehic ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL COOLER DRYER (a) Using pliers, install the cooler dryer. (b) Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring and the cap. Compressor oil: ND-OIL 8 or equivalent ...

Correct driving posture
Drive with a good posture as follows: 1. Sit upright and well back in the seat. 2. Adjust the position of the seat forward or backward to ensure the pedals can be reached and easily depressed to the extent required. 3. Adjust the seatback so that the ...