Toyota 4Runner: Extension Housing Rear Oil Seal
Components
COMPONENTS
ILLUSTRATION
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE PROPELLER SHAFT ASSEMBLY
(a) Remove the propeller shaft (See page .gif)
).
2. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL
(a) Using SST, remove the oil seal.
SST: 09308-00010
3. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
|
(b) Using SST and a hammer, tap in the oil seal. SST: 09316-60011 09316-00011 09316-00051 Standard depth: 5.4 to 5.8 mm (0.213 to 0.228 in.) |
|
4. INSTALL PROPELLER SHAFT ASSEMBLY
(a) Install the propeller shaft (See page ).
5. ADD AUTOMATIC TRANSMISSION FLUID
(a) Add automatic transmission fluid (See page
).
Reassembly
REASSEMBLY
PROCEDURE
1. BEARING POSITION
Bearing and Race Diameter:
Mark
Front Race Diameter Inside/Outside
Thrust Bearing Diameter Inside/Outside
Re ...
Oil Cooler
...
Other materials about Toyota 4Runner:
Initialization
INITIALIZATION
1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL
NOTICE:
After the battery is reconnected, be sure to wait 10 seconds or more
before attempting to start the engine. The engine may not start immedi ...
Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446/46)
DESCRIPTION
The damper servo sub-assembly (driver side air mix damper servo) sends pulse
signals to inform the No. 1 air conditioning amplifier assembly of the damper position.
The No. 1 air conditioning amplifier assembly activates the motor (normal or r ...
0.0104