Toyota 4Runner: Front Brake Flexible Hose

Toyota 4Runner Service Manual / Brake / Brake (front) / Front Brake Flexible Hose

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.

3. REMOVE FRONT FLEXIBLE HOSE

(a) Remove the 2 clips.

(b) Disconnect the brake tube from the front flexible hose with a union nut wrench while holding the front flexible hose with a wrench and remove the front flexible hose.

NOTICE:

Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT FLEXIBLE HOSE

(a) Using a union nut wrench, connect the brake tube to the front flexible hose while holding the front flexible hose with a wrench to install the front flexible hose.

Torque:

15 N·m {155 kgf·cm, 11 ft·lbf}

NOTICE:

Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page ).

(b) Install 2 new clips to the front flexible hose.

2. BLEED BRAKE LINE

3. INSTALL FRONT WHEEL

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT DISC (a) Al ...

Other materials about Toyota 4Runner:

Precaution
PRECAUTION 1. PRECAUTIONS FOR EACH FUNCTION (a) Precautions for the key: The key is a precision instrument. Be sure to observe the following: (1) Do not drop or strike the key. (2) Do not keep the key in a high temperature area for a long ...

Ignition Key Cylinder Light
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE NO. 2 SWITCH HOLE BASE 2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 4. REMOVE LOWER STEERING COLUMN ...

Toyota 4Runner: Front Brake Flexible Hose

Installation

Brake (rear)

Other materials about Toyota 4Runner: