Toyota 4Runner: Front Door Belt Moulding

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...

Pressure Sensor Malfunction / Upside (C1812/12)
DESCRIPTION In the KDSS hydraulic circuit, the fluid is contained under pressure. If the fluid temperature is 20°C (68°F), the pressure is approximately 3.0 MPa (30.6 kgf/cm2, 435 psi). DTC Code DTC Detection Condition ...