Toyota 4Runner: Front Door Courtesy Switch

Toyota 4Runner Service Manual / Vehicle Interior / Lighting (int) / Front Door Courtesy Switch

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
1 - Switch body	Pin not pushed	Below 1 Ω
1 - Switch body	Pin pushed	10 kΩ or higher

If the result is not as specified, replace the front door courtesy light switch assembly.

Text in Illustration

*a	Component without harness connected (Front Door Courtesy Light Switch Assembly)

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the screw and courtesy light switch.

(b) Disconnect the connector.

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Connect the connector.

(b) Using a T30 "TORX" socket wrench, install the courtesy light switch with the screw.

Door Courtesy Light(for Rear Door)

Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. ...

Ignition Key Cylinder Light

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE NO. 2 SWITCH HOLE BASE 2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 3. REMOVE INSTRUMENT CLUSTER FI ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after d ...

Inside rear view mirror
Glare from the headlights of vehicles behind can be reduced by using the following functions: Manual anti-glare inside rear view mirror 1. Normal position 2. Anti-glare position Auto anti-glare inside rear view mirror In automatic mode, sensors are u ...