Toyota 4Runner: Front Fog Light Circuit

Toyota 4Runner Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System / Front Fog Light Circuit

DESCRIPTION

The main body ECU receives headlight dimmer switch information signals, and illuminates the front fog light.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.	PERFORM ACTIVE TEST USING TECHSTREAM (FRONT FOG LIGHT RELAY)

(a) Using the Techstream, perform the Active Test (See page ).

Main Body

Tester Display	Test Part	Control Range	Diagnostic Note
Front Fog Light Relay	Front fog light relay	ON/OFF	-

OK:

Front fog light relay operates (front fog lights come on).

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

2.	CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Switch Condition	Specified Condition
2D-9 - Body ground	Headlight dimmer switch in tail and front fog light switch on	11 to 14 V

Text in Illustration

*a	Component with harness connected (Driver Side Junction Block Assembly)

REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - FOG LIGHT ASSEMBLY)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Headlight (HI-BEAM) Circuit

DESCRIPTION The main body ECU (multiplex network body ECU) receives headlight dimmer switch information signals, and illuminates the high beam headlight. WIRING DIAGRAM CAUTION / NOTICE / HINT ...

Taillight Relay Circuit

DESCRIPTION The main body ECU receives headlight dimmer switch information signals, and illuminates the clearance lights, taillights and license plate lights. WIRING DIAGRAM CAUTION / NOTICE / ...

Other materials about Toyota 4Runner:

Washer Nozzle(for Rear Side)
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: The washer fluid does not spray if the back door and back door glass are not closed. PROCEDURE 1. INSPECT REAR WASHER NOZZLE (a) With ...

USB Audio System Recognition/Play Error
DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the navigation receiver assembly. This diagno ...