DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B15C0 |
Navigation antenna error |
|
|
B15C1 |
Error of the power source to the navigation antenna |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
|
|
2. |
CHECK CONNECTION OF NAVIGATION ANTENNA CORD |
(a) Check if the navigation antenna cord is securely connected to the radio and display receiver assembly.
OK:
Navigation antenna cord is securely connected.
| NG | |
SECURELY CONNECT NAVIGATION ANTENNA CORD |
|
|
3. |
INSPECT NAVIGATION ANTENNA ASSEMBLY |
(a) Remove the navigation antenna assembly (See page
).
(b) Inspect the navigation antenna assembly (See page
).
| OK | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| NG | |
REPLACE NAVIGATION ANTENNA ASSEMBLY |
Speaker Output Short (B15C3)
XM Tuner Malfunction (B15BA)Pressure Sensor Malfunction / Upside (C1812/12)
DESCRIPTION
In the KDSS hydraulic circuit, the fluid is contained under pressure. If the
fluid temperature is 20°C (68°F), the pressure is approximately 3.0 MPa (30.6 kgf/cm2,
435 psi).
DTC Code
DTC Detection Condition
...
Rear Speed Sensor RH Performance (C1411,C1412)
DESCRIPTION
Refer to DTCs C1401 and C1402 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1411
C1412
One of the following conditions is met:
When the vehicle is driven ...