DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRAC operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.
This DTC is cleared when the IG1 terminal voltage returns to normal.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1417 |
The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more. |
|
WIRING DIAGRAM
Refer to DTC C1241 (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
CHECK TERMINAL VOLTAGE (IG1) |
NG |
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) |
|
2. |
RECONFIRM DTC |
(a) Clear the DTCs (See page ).
(b) Turn the ignition switch off.
(c) Check for DTCs (see page ).
Result |
Proceed to |
---|---|
DTC is output |
A |
DTC is not output |
B |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
USE SIMULATION METHOD TO CHECK |
Operation Check
OPERATION CHECK
1. INSPECT INDICATOR/WARNING LIGHT
(a) Check the following indicators and warning lights.
Indicator/Warning Light
Switch Condition
Specified Condition
Tire pressure warning light
I ...
No Response from Steering Lock ECU (B2786)
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU and steering
lock actuator assembly (steering lock ECU) stops for 10 seconds or more.
DTC Code
DTC Detection Condition
Trouble Area
...