DESCRIPTION
When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the horn(s) to sound.
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HORN OPERATION |
(a) Press the horn switch and check if the horn(s) sound.
OK:
Horn(s) operate normally.
NG |
GO TO HORN SYSTEM |
|
2. |
PERFORM ACTIVE TEST USING TECHSTREAM (VEHICLE HORN) |
(a) Operate the Techstream according to the steps on the display and select Active Test (See page ).
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
---|---|---|---|
Vehicle Horn |
Vehicle horn(s) |
ON/OFF |
- |
OK:
Horn(s) operate normally.
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
3. |
CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - MAIN BODY ECU) |
(a) Disconnect the 1C relay connector.
(b) Remove the main body ECU (See page ).
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
1C-7 - A-28 (HORN) |
Always |
Below 1 Ω |
1C-7 or A-28 (HORN) - Body ground |
Always |
10 kΩ or higher |
OK |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Selecting trailer ball
Use the correct trailer ball for your application.
1. Trailer ball load rating Matches or exceeds the gross trailer weight
rating of the trailer.
2. Ball diameter Matches the size of the trailer coupler. Most couplers are
stamped with the required trai ...
Garage door opener
The garage door opener can be programmed to operate garage doors, gates,
entry doors, door locks, home lighting systems, security systems, and other
devices.
The garage door opener (HomeLink® Universal Transceiver) is manufactured
under license from Ho ...