CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, inspect the CAN communication function to make sure that there are no malfunctions in the communication system (See page ).
Result |
Proceed to |
---|---|
No DTCs are output |
A |
DTCs are output |
B |
B |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
(a) Using the Techstream, inspect the LIN communication function to make sure that there are no malfunctions in the communication system (See page ).
Result |
Proceed to |
---|---|
No DTCs are output |
A |
DTCs are output |
B |
B |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to the Problem Symptoms Table (See page ).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 7 |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List/Active Test (See page ).
(b) Terminals of ECU (See page
).
|
7. |
ADJUST, REPAIR OR REPLACE |
NEXT |
END |
Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS
1. NOTICE ABOUT VEHICLE CONDITION WHEN RAISING VEHICLE
(a) The vehicle must be unloaded before jacking up or raising the vehicle. Never
jack up or raise a heavily loaded vehicle.
(b) When removing any heavy components li ...
Airbag Signal Malfunction/Not Input (B15C4)
DESCRIPTION
If the DCM (Telematics Transceiver) detects an error in the communication between
the DCM (Telematics Transceiver) and center airbag sensor assembly as a result of
the DCM (Telematics Transceiver) self check, this DTC will be set.
...