CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CHECK DTC* |
(a) Check for DTCs and make a note of any codes that are output (See page ).
(b) Clear the DTCs (See page ).
(c) Recheck for DTCs (See page ). Based on the
DTCs output above, try to cause the output of the same wireless door lock control
system DTC, LIN communication system DTC, steering lock system DTC, engine immobiliser
system DTC or smart key system (for entry function) DTC by reproducing the symptoms
indicated by the DTC.
Result |
Proceed to |
---|---|
DTC is not output. |
A |
Wireless door lock control system DTC is output. |
B |
LIN communication system DTC is output. |
C |
Steering lock system DTC is output. |
D |
Engine immobiliser system DTC is output. |
E |
Smart key system (for entry function) DTC is output. |
F |
B |
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) |
C |
GO TO LIN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) |
D |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
E |
GO TO ENGINE IMMOBILISER SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) |
F |
GO TO SMART KEY SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) |
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table. |
A |
Fault is listed in problem symptoms table. |
B |
B |
GO TO STEP 6 |
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU (See page ).
(b) Data List / Active Test (See page ).
|
6. |
REPAIR OR REPLACE |
|
7. |
CONFIRMATION TEST |
NEXT |
END |
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
2. REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
3. REMOVE REAR DOOR SCUFF PLATE RH
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
5. REMOVE NO. 1 LUGGAGE COM ...
Automatic transmission
Select a shift position appropriate for the driving conditions.
Shifting the shift lever
Vehicles without a smart key
system:
While the engine switch is in the “ON” position, move the shift lever with
the brake pedal depressed.
Vehicles with a s ...