CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
CUSTOMER PROBLEM ANALYSIS |
|
|
3. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
|
4. |
INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Inspect the CAN communication function to make sure there are no malfunctions
in the communication system (See page
).
|
Result |
Proceed to |
|---|---|
|
CAN DTC is not output |
A |
|
CAN DTC is output |
B |
| B | |
GO TO CAN COMMUNICATION SYSTEM |
|
|
5. |
CHECK AND CLEAR DTC |
(a) Check for DTCs (See page
).
|
|
6. |
PROBLEM SYMPTOM CONFIRMATION |
|
Result |
Proceed to |
|---|---|
|
Symptom does not occur |
A |
|
Symptom occurs |
B |
| B | |
GO TO STEP 9 |
|
|
7. |
SYMPTOM SIMULATION |
|
|
8. |
CHECK DTC* |
(a) Check for DTCs (See page
).
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| B | |
GO TO STEP 10 |
|
|
9. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
| NEXT | |
GO TO STEP 12 |
|
10. |
DTC CHART |
(a) Refer to the Diagnostic Trouble Code Chart (See page
).
|
|
11. |
CIRCUIT INSPECTION |
|
|
12. |
IDENTIFICATION OF PROBLEM |
|
|
13. |
REPAIR OR REPLACE |
|
|
14. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
System DescriptionInspection
INSPECTION
PROCEDURE
1. INSPECT DOOR CONTROL SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Speci ...
Brake Line
Precaution
PRECAUTION
CAUTION:
Make sure to replace each part properly. Improper installation or repair could
affect the performance of the brake system and cause a driving hazard.
NOTICE:
It is very important to keep the brake system parts an ...