CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the automatic running board system.
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CHECK FOR DTC |
(a) Check for DTCs and make a note of any codes that are output.
Result |
Proceed to |
---|---|
No DTCs are output |
A |
DTC is output |
B |
B |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to the Problem Symptoms Table (See page ).
Result |
Proceed to |
---|---|
Fault not listed in problem symptoms table |
A |
Fault listed in problem symptoms table |
B |
B |
GO TO STEP 6 |
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Operation Check (See page ).
(b) Terminals of ECU (See page ).
|
6. |
REPAIR OR REPLACE |
|
7. |
CONFIRMATION TEST |
NEXT |
END |
Stabilizer Control Ecu
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
N ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining assembly (See page
).
2. ...