Toyota 4Runner: How To Proceed With Troubleshooting

Toyota 4Runner Service Manual / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the sliding roof system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

3.	CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result	Proceed to
CAN DTC is not output	A
CAN DTC is output	B

GO TO CAN COMMUNICATION SYSTEM

4.	CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the LIN communication system is functioning normally.

Result	Proceed to
LIN DTC is not output	A
LIN DTC is output	B

GO TO LIN COMMUNICATION SYSTEM

5.	CHECK FOR DTC*

(a) Check for DTCs and note any codes that are output (See page ).

(b) Clear the DTCs.

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

6.	PROBLEM SYMPTOMS TABLE

(a) Refer to the Problem Symptoms Table (See page ).

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

GO TO STEP 8

7.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page ).

(b) Data List / Active Test (See page ).

8.	ADJUST, REPAIR OR REPLACE

9.	INITIALIZATION

(a) Initialization (See page ).

10.	CONFIRMATION TEST

END

System Description

SYSTEM DESCRIPTION 1. GENERAL This system has the following functions: manual slide open and close, auto slide open and close, manual tilt up and down, auto tilt up and down, jam protection, key ...

Operation Check

OPERATION CHECK NOTICE: Perform initialization before performing the operation check. 1. CHECK AUTO OPERATION HINT: When pressing the switch for 0.3 seconds or less, the roof glass moves but auto ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE F ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all front propeller shaft universal joint spider bearing. (a) Place matchmarks on the flange yoke and sleeve yoke. Text in Illustration ...