Toyota 4Runner: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
- Use these procedures to troubleshoot the power door lock control system.
- *: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Check if the CAN communication system is functioning normally (See page
.gif)
).
|
Result |
Proceed to |
|---|---|
|
CAN DTC is not output |
A |
|
CAN DTC is output |
B |
| B | .gif) |
GO TO CAN COMMUNICATION SYSTEM |
|
|
4. |
CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the LIN communication system is functioning normally.
|
Result |
Proceed to |
|---|---|
|
LIN DTC is not output |
A |
|
LIN DTC is output |
B |
| B | |
GO TO LIN COMMUNICATION SYSTEM |
|
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in problem symptoms table |
A |
|
Fault is listed in problem symptoms table |
B |
| B | |
GO TO STEP 7 |
|
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page ).
(b) Terminals of ECU (See page ).
(c) Data List / Active Test (See page ).
|
|
7. |
ADJUST, REPAIR OR REPLACE |
|
|
8. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Line
Combination meter assembly
Main body ECU (Multiplex network ...
System Description
SYSTEM DESCRIPTION
1. POWER DOOR LOCK CONTROL SYSTEM DESCRIPTION
(a) The power door lock system locks/unlocks all the doors.
The driver and front passenger side door control switches send lock/unlo ...
Other materials about Toyota 4Runner:
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
Water or deteriorated brake fluid. Sealed areas or brake fluid may deteriorate
and lead to fluid leaks or decreased efficiency.
PROCEDURE
1. CHECK FLUID LEVEL IN RESERVOIR
(a) Turn the en ...
Alarm
The system sounds the alarm and flashes the lights when forced entry is
detected.
Triggering of the alarm
The alarm is triggered in the following situations when the alarm is set:
• A locked door is unlocked or opened in any way other than using the ...
0.0068