Toyota 4Runner: How To Proceed With Troubleshooting

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Wireless Door Lock Control System(w/ Smart Key System) / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use these procedures to troubleshoot the wireless door lock control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

3.	CHECK FOR DTC*

(a) Check for DTCs and note any codes that are output (See page ).

(b) Clear the DTCs (See page ).

(c) Recheck for DTCs (See page ). Based on the
DTCs output above, try to force output of the same CAN communication system DTC, LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.

Result	Proceed to
DTC is not output	A
CAN communication system DTC is output	B
LIN communication system DTC is output	C
Wireless door lock control system DTC is output	D

GO TO CAN COMMUNICATION SYSTEM

GO TO LIN COMMUNICATION SYSTEM

GO TO DIAGNOSTIC TROUBLE CODE CHART

4.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page
).

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

GO TO STEP 6

5.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page ).

(b) Terminals of ECU (See page ).

6.	REPAIR OR REPLACE

7.	CONFIRMATION TEST

END

System Diagram

SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Certification ECU Main body ECU Door unl ...

Customize Parameters

CUSTOMIZE PARAMETERS 1. CUSTOMIZING FUNCTION WITH TECHSTREAM NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure ...

Other materials about Toyota 4Runner:

Road Test
ROAD TEST 1. PROBLEM SYMPTOM CONFIRMATION (a) Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transmission does not shift up or shift down, or that the shift point is too high or too low, co ...

Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL NO. 1 SEAT 3 POINT ...