CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CHECK FOR DTC* |
(a) Check for DTCs and note any codes that are output (See page ).
(b) Clear the DTCs (See page ).
(c) Recheck for DTCs. Based on the DTCs output above, try to force output of the same LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.
Result |
Proceed to |
---|---|
DTC is not output |
A |
LIN communication system DTC is output |
B |
Wireless door lock control system DTC is output |
C |
B |
GO TO LIN COMMUNICATION SYSTEM |
C |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 6 |
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page ).
(b) Terminals of ECU (See page ).
(c) Data List / Active Test (See page ).
|
6. |
REPAIR OR REPLACE |
|
7. |
CONFIRMATION TEST |
NEXT |
END |
Steering Lock Position Signal Circuit Malfunction (B2285)
DESCRIPTION
The power management control ECU and steering lock actuator (steering lock ECU)
are connected by a cable and the LIN communication line. This DTC is stored when
the steering lock position signal information from the cable and the steering lock ...
Green And Red Indicators Do Not Come On When Ig-on
DESCRIPTION
If the red and green indicators fail to illuminate after the ignition switch
is turned to ON, the vehicle does not recognize the DCM (Telematics Transceiver).
The DCM (Telematics Transceiver) connectors may have been disconnected or the DCM
...