CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 5 |
|
4. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page ).
(b) Terminals of ECU (See page ).
(c) Data List / Active Test (See page ).
|
5. |
ADJUST, REPAIR OR REPLACE |
|
6. |
CONFIRMATION TEST |
NEXT |
END |
Data Signal Circuit between Radio Receiver and Extension Module
DESCRIPTION
The stereo component tuner assembly sends the sound data signal or image data
signal from a device to the radio and display receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR ( ...
Side Auto Step LH Stowing Timeout (51-56)
DESCRIPTION
When fully deploying or stowing the automatic running board takes more than 4
seconds, or when the side auto step motor hall sensor pulse signal exceeds the maximum
pulse count, the side auto step ECU halts the operation of the automatic runni ...