CAUTION / NOTICE / HINT
Use these procedures to troubleshoot the clock system.
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 5 |
|
4. |
OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Terminals of ECU (See page ).
|
5. |
ADJUST, REPAIR OR REPLACE |
|
6. |
CONFIRMATION TEST |
NEXT |
END |
Accumulator Low Pressure (C1452)
DESCRIPTION
DTC Code
DTC Detection Condition
Trouble Area
C1452
After braking, the fluid pressure inside the accumulator is below the
threshold within 3.2 seconds.
Hydrauli ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Using a T25 "TORX" socket wrench, install the back power window regulator
motor assembly with the 3 screws.
HINT:
Tighten the sc ...