CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).
Result |
Proceed to |
---|---|
CAN DTC is not output |
A |
CAN DTC is output |
B |
B |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
CHECK DTC OUTPUT* |
(a) Check for DTCs (See page ).
(b) Clear the DTCs (See page ).
(c) Recheck for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO STEP 7 |
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 7 |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page )
(b) Data List / Active Test (See page )
(c) Terminals of ECU (See page )
|
7. |
REPAIR OR REPLACE |
|
8. |
CONFIRMATION TEST |
NEXT |
END |
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ign ...
Center Airbag Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Center Airbag Sensor Communication Stop Mode
Either condition is met:
"SRS Airbag" is not displayed on the "CAN Bus Check ...