CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
3. |
CHECK FOR DTC* |
(a) Check for DTCs and make a note of any codes that are output.
(b) Clear the DTCs.
(c) Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC, airbag system DTC or occupant classification system DTC by simulating the symptoms indicated by the DTC.
Result |
Proceed to |
---|---|
DTC is not output |
A |
CAN communication system DTC is output |
B |
Airbag system DTC is output |
C |
Occupant classification system DTC is output |
D |
B |
GO TO CAN COMMUNICATION SYSTEM |
C |
GO TO AIRBAG SYSTEM |
D |
GO TO OCCUPANT CLASSIFICATION SYSTEM |
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page ).
(b) Data List / Active Test (See page ).
(c) Terminals of ECU (See page ).
|
6. |
REPAIR OR REPLACE |
|
7. |
CONFIRMATION TEST |
NEXT |
END |
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable some systems need to be initialized after the cable,
is reconnected (See page ).
2. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
3. ...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK WARNING LIGHT
NOTICE:
When there is a problem with the tire pressure warning system, the tire
pressure warning light blinks at 0.5 second intervals and comes on after
1 minute.
When the malfunction has been corr ...