CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CHECK CAN COMMUNICATION SYSTEM* |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
WARNING LIGHT CHECK |
|
5. |
CHECK DTC (Present and Past DTCs)* |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO PROBLEM SYMPTOMS TABLE |
|
6. |
DTC CHART |
|
7. |
CIRCUIT INSPECTION |
|
8. |
REPAIR |
|
9. |
CLEAR DTC (Present and Past DTCs)* |
|
10. |
CHECK DTC (Present and Past DTCs)* |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
11. |
CONFIRMATION TEST |
NEXT |
END |
No Communication in Immobiliser System (B2796,B2798)
DESCRIPTION
DTC B2796 is stored when a key is inserted into the ignition key cylinder
but no communication occurs between the key and transponder key ECU assembly.
DTC B2798 is stored when a key is inserted into the ignition key cylinder
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the window frame moulding, black out tape and outside
stripe, heat the vehicle body, windo ...