CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
|
3. |
PASSENGER AIRBAG ON/OFF INDICATOR CHECK |
|
4. |
CHECK DTC (Present and Past DTCs)* |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is output. |
A |
DTC is not output. |
B |
B |
GO TO PROBLEM SYMPTOMS TABLE |
|
5. |
DTC CHART |
|
6. |
CIRCUIT INSPECTION* |
|
7. |
REPAIR |
|
8. |
CLEAR DTCS (Present and Past DTCs)* |
(a) Clear the DTCs (See page ).
|
9. |
CHECK DTC (Present and Past DTCs)* |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO STEP 5 |
|
10. |
SYMPTOM SIMULATION |
(a) Check the passenger airbag ON/OFF indicator condition.
Result |
Proceed to |
---|---|
Passenger airbag ON/OFF indicator is operating normally. |
A |
Passenger airbag ON/OFF indicator ("OFF") and SRS warning light come on. |
B |
B |
GO TO STEP 5 |
|
11. |
CONFIRMATION TEST |
NEXT |
END |
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
(a) Remove any dust and oil from the differential carrier assembly and the contact
surfaces of the axle housing.
(b) Install a new gasket and the differential carrier assembly with the ...
Detecting Vehicle Submersion (B2277)
DESCRIPTION
This DTC is stored when a malfunction in the submersion monitor circuit inside
the power management control ECU is detected.
HINT:
When the power management control ECU is replaced with a new one and the cable
is connected to the negative (- ...