CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CRANK ENGINE FOR MORE THAN 10 SECONDS |
|
4. |
CHECK FOR DTC* |
(a) Check for DTCs and note any codes that are output (See page ).
(b) Clear the DTCs (See page ).
(c) Recheck for DTCs. Try to duplicate the DTC (SFI system and engine immobiliser system) by reproducing the symptoms indicated by the DTC.
Result |
Proceed to |
---|---|
DTC is not output |
A |
SFI system DTC is output |
B |
Engine immobiliser system DTC is output |
C |
B |
GO TO SFI SYSTEM |
C |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B |
GO TO STEP 7 |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test (See page ).
(b) Terminals of ECU (See page ).
|
7. |
ADJUST, REPAIR OR REPLACE |
|
8. |
CONFIRMATION TEST |
NEXT |
END |
Security Horn Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE AIR CLEANER CAP AND HOSE
2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
3. REMOVE SECURITY HORN ASSEMBLY
(a) Disconnect the connector.
...
Ambient Temperature Sensor Circuit (B1412/12)
DESCRIPTION
The cooler thermistor (ambient temperature sensor) is installed in the front
part of the cooler condenser assembly to detect the ambient temperature and control
the air conditioning auto mode. The sensor connected to the air conditioning ampli ...