Toyota 4Runner: Initialization

Toyota 4Runner Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Initialization

INITIALIZATION

1. OIL MAINTENANCE INFORMATION MODE RESET OPERATION

NOTICE:

When "Oil Maintenance Required Soon" is displayed, change the engine oil and perform this procedure.
After the engine oil is changed, perform this procedure so that "Oil Maintenance Required Soon" does not display.

HINT:

The oil change maintenance system displays "Oil Maintenance Required Soon" in the multi-information display to inform the driver that it is time to change the oil based on the distance driven.

(a) Turn the ignition switch to ON, and use the ODO/TRIP switch to change the screen display to TRIP A.

(b) Turn the ignition switch off.

(d) After a 5 second count, reset will end.

NOTICE:

If the ignition switch is turned off during the reset operation, reset mode will be canceled.
If the ODO/TRIP switch is turned off during the reset operation, reset mode will be canceled.

2. METHOD TO DISABLE ECO DRIVING INDICATOR LIGHT

HINT:

The eco driving indicator light can be disabled through the customize function.
When the eco driving indicator light is disabled, the initial check for the eco driving indicator light is not performed by the system.

(a) With the vehicle stationary or at a vehicle speed of less than 8 km/h (4.9 mph), press and hold the DISP switch on the steering pad switch to display the meter customize mode screen.

(b) Press the DISP switch on the steering pad switch to display the "ECO LAMP" screen, and then press the DISP switch.

HINT:

The eco driving indicator light can be enabled by selecting "ON".

(d) Press the DISP switch on the steering pad switch to end meter customize mode.

Calibration

CALIBRATION Initial Calibration of Compass: The compass indicates the direction that the vehicle is heading by detecting the direction and strength of the earth's magnetic field and processing ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT PROCEDURE 1. REMOVE OUTER MIRROR LH (a) Put protective tape around the outer mirror LH. (b) Using a moulding remover, detach the 2 claws of the outer mirror LH as shown in the illustration. Text in Ill ...

Inspection
INSPECTION PROCEDURE 1. INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING (a) Using a micrometer, measure the outer diameter of the vane pump shaft. Text in Illustration *a Outer Diameter ...