INSPECTION
PROCEDURE
1. INSPECT TIE ROD END SUB-ASSEMBLY
(a) Install the nut. |
|
(b) Flip the ball joint stud back and forth 5 times as shown in the illustration.
(c) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and check the torque reading on the 5th turn.
Standard Torque:
1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)
2. INSPECT TOTAL PRELOAD
(a) Place matchmarks as shown in the illustration. Text in Illustration
|
|
(b) Temporarily install the 2 steering rack ends to the steering rack.
NOTICE:
Do not fully turn the steering rack without the steering rack ends installed as it may damage the oil seal in the rack housing.
(c) Using SST, fully turn the steering rack right and left 10 times to settle it. SST: 09616-00011 |
|
(d) Using SST, turn the control valve and measure the preload. SST: 09616-00011 Standard preload (turning): 1.6 to 2.3 N*m (16 to 23 kgf*cm, 14 to 20 in.*lbf) If the turning torque is not as specified, replace the steering gear assembly. HINT:
|
|
(e) After inspecting the preload, align the matchmarks.
Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor
via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data s ...
Short in Sensor with Motor Power Supply Circuit (B2658)
DESCRIPTION
This DTC is stored when a power seat motor operates (a position control sensor
is being supplied with power) and the power supply voltage does not rise to the
specified value.
DTC Code
DTC Detection Condition
...