Toyota 4Runner: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY LH
(a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation.
If there is any abnormality, replace the front shock absorber assembly LH with a new one.
NOTICE:
When disposing of the front shock absorber assembly LH, refer to Disposal (See
page .gif)
).
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
(a) Secure SST in a vise.
SST: 09727-30021
09727-00010
09727-00031
SST: 09727-00060
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT SHOCK ABSORBER BUSH
(a) Using SST and a press, install a new absorber bush.
SST: 09710-30012
09710-04071
09710-04081
...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY
(a) Temporarily install the housing with the 8 bolts (vehicle body side) and
8 nuts.
(b) Tighten the 8 nuts in alphabetical order.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) Tight ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL LOWER BALL JOINT DUST COVER LH
(a) Pack the lower arm ball joint with MP grease.
Grease capacity:
8.0 g (0.282 oz.)
(b) Apply MP grease to the locations shown in the illustration.
Text in Illustration
...
0.0075